Thinking that all the deferred maintenance was done and parking the car after a drive, I discovered some of that tell-tale blue-green water leaking out from under the car. A closer look under the hood, coolant was leaking out of the coolant reservoir pressure tank, a common problem with all of the plastic used in the BMW coolant system.


With a new tank in hand I drained some of the coolant from the car and removed the defective tank. I installed the new tank and connected the hoses. I refilled the reservoir but I could not get the trapped air out of the system. I learned that trapped air is a common problem with the BMW Z3. I also learned that the gold standard for refilling the coolant system is to use vacuum. I found a vacuum tool that is well suited for the BMW. Once it was hooked up it was a quick matter to create a vacuum and then draw the coolant into the system. Problem solved and no new leaks appeared.


Once the work on the coolant system was done, I figured it was time to refill the windshield washer reservoir. It was the next day that I noted that some of the windshield washer fluid was finding its way to garage floor. New to BMWs I went to the web and found the windshield washer tanks are prone to cracking. I also learned that replacement tanks are a bit pricey. Once the tank was pulled out it was relatively easy to find the cracks…some of which had been repaired in the past. The polyethylene plastics used for these tanks are notoriously difficult to repair. After a little more online research, I learned that using a two-part epoxy and cloth you can patch the tank. After sanding and cleaning the areas to be repaired, the epoxy was prepared and the patches were put in place. After letting the epoxy cure, I filled the tank and found no leaks. As a fall back I did order a new tank in case my repairs did not work.
